[dpdk-dev] [PATCH 28/32] net/ngbe: add IPsec context creation

[Hemant Agrawal]

On 9/15/2021 10:28 PM, Ferruh Yigit wrote:
> On 9/8/2021 9:37 AM, Jiawen Wu wrote:
>> Initialize securiry context, and support to get security
>> capabilities.
>>
>> Signed-off-by: Jiawen Wu <jiawenwu at trustnetic.com>
> <...>
>
>> --- a/drivers/net/ngbe/ngbe_ethdev.c
>> +++ b/drivers/net/ngbe/ngbe_ethdev.c
>> @@ -430,6 +430,12 @@ eth_ngbe_dev_init(struct rte_eth_dev *eth_dev, void *init_params __rte_unused)
>>   	/* Unlock any pending hardware semaphore */
>>   	ngbe_swfw_lock_reset(hw);
>>   
>> +#ifdef RTE_LIB_SECURITY
>> +	/* Initialize security_ctx only for primary process*/
>> +	if (ngbe_ipsec_ctx_create(eth_dev))
>> +		return -ENOMEM;
>> +#endif
> Hi Hemant,
>
> I see 'RTE_LIB_SECURITY' is still used in some PMDs, as this new PMD also uses it?
> Previously I assume this macro was to mark that security library is enabled, is
> this macro still valid? Who should set this macro now?
>
> Also can you please help reviewing this and next a few patches since they are
> related to the security?

Hi Ferruh,

      It indicate if the driver is using SECURITY library functions. In 
Ethernet driver, it typically means the inline security offload.

Ok, I will try to review.


regards,

Hemant

>