[PATCH v4] sched: enable CMAN at runtime

[Dumitrescu, Cristian]

> -----Original Message-----
> From: Danilewicz, MarcinX <marcinx.danilewicz at intel.com>
> Sent: Monday, June 13, 2022 10:09 AM
> To: dev at dpdk.org; Singh, Jasvinder <jasvinder.singh at intel.com>;
> Dumitrescu, Cristian <cristian.dumitrescu at intel.com>
> Cc: Ajmera, Megha <megha.ajmera at intel.com>
> Subject: [PATCH v4] sched: enable CMAN at runtime
> 
> Added changes to enable CMAN (RED or PIE) at init
> from profile configuration file.
> 
> By default CMAN code is enable but not in use, when
> there is no RED or PIE profile configured.
> 
> Signed-off-by: Marcin Danilewicz <marcinx.danilewicz at intel.com>
> ---
> Log: v2 change in rte_sched.h to avoid ABI breakage.
>      v3 changes from comments
> ---
>  config/rte_config.h                      |   3 -
>  drivers/net/softnic/rte_eth_softnic_tm.c |  12 --
>  examples/ip_pipeline/tmgr.c              |   4 -
>  examples/qos_sched/cfg_file.c            |  11 +-
>  examples/qos_sched/cfg_file.h            |   2 -
>  examples/qos_sched/init.c                |   4 -
>  examples/qos_sched/main.h                |   2 -
>  examples/qos_sched/profile.cfg           | 130 ++++++++++-----------
>  examples/qos_sched/profile_pie.cfg       | 142 ++++++++++++++++++++++
>  examples/qos_sched/profile_red.cfg       | 143 +++++++++++++++++++++++
>  lib/sched/rte_sched.c                    |  47 +-------
>  11 files changed, 359 insertions(+), 141 deletions(-)
>  create mode 100644 examples/qos_sched/profile_pie.cfg
>  create mode 100644 examples/qos_sched/profile_red.cfg
> 

Marcin,

Code changes look good to me, but still not able to cleanly apply this patch on top of DPDK latest with git am, can you please make sure this gets fixed?

Applying: sched: enable CMAN at runtime
error: patch failed: config/rte_config.h:88
error: config/rte_config.h: patch does not apply
Patch failed at 0001 sched: enable CMAN at runtime
Use 'git am --show-current-patch' to see the failed patch
When you have resolved this problem, run "git am --continue".
If you prefer to skip this patch, run "git am --skip" instead.
To restore the original branch and stop patching, run "git am --abort".

Regards,
Cristian