[PATCH V6 5/5] app/testpmd: stop forwarding in new or destroy event

[Huisong Li]

When testpmd receives the new or destroy event, the port related
information will be updated. Testpmd must stop packet forwarding
before updating the information to avoid some serious problems.

Signed-off-by: Huisong Li <lihuisong at huawei.com>
---
 app/test-pmd/testpmd.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/app/test-pmd/testpmd.c b/app/test-pmd/testpmd.c
index f03b3dfb84..7d9d6decc9 100644
--- a/app/test-pmd/testpmd.c
+++ b/app/test-pmd/testpmd.c
@@ -3939,6 +3939,8 @@ eth_event_callback(portid_t port_id, enum rte_eth_event_type type, void *param,
 
 	switch (type) {
 	case RTE_ETH_EVENT_NEW:
+		if (test_done == 0)
+			stop_packet_forwarding();
 		if (setup_on_probe_event)
 			setup_attached_port(port_id);
 		break;
@@ -3949,6 +3951,8 @@ eth_event_callback(portid_t port_id, enum rte_eth_event_type type, void *param,
 				"Could not set up deferred device removal\n");
 		break;
 	case RTE_ETH_EVENT_DESTROY:
+		if (test_done == 0)
+			stop_packet_forwarding();
 		ports[port_id].port_status = RTE_PORT_CLOSED;
 		printf("Port %u is closed\n", port_id);
 		if (rte_eal_alarm_set(100000, remove_invalid_ports_callback,
-- 
2.22.0