[PATCH 18/24] net/axgbe: delay AN timeout during KR training

[Venkat Kumar Ande]

AN restart triggered during KR training not only aborts the KR training
process but also move the HW to unstable state. Driver has to wait up to
500ms or until the KR training is completed before restarting AN cycle.

Signed-off-by: Venkat Kumar Ande <VenkatKumar.Ande at amd.com>
---
 drivers/net/axgbe/axgbe_ethdev.h |  2 ++
 drivers/net/axgbe/axgbe_mdio.c   | 25 +++++++++++++++++++++++++
 2 files changed, 27 insertions(+)

diff --git a/drivers/net/axgbe/axgbe_ethdev.h b/drivers/net/axgbe/axgbe_ethdev.h
index 127427c736..4dcbf6d9a2 100644
--- a/drivers/net/axgbe/axgbe_ethdev.h
+++ b/drivers/net/axgbe/axgbe_ethdev.h
@@ -111,6 +111,7 @@
 /* Auto-negotiation */
 #define AXGBE_AN_MS_TIMEOUT		500
 #define AXGBE_LINK_TIMEOUT		5
+#define AXGBE_KR_TRAINING_WAIT_ITER	50
 
 #define AXGBE_SGMII_AN_LINK_STATUS	BIT(1)
 #define AXGBE_SGMII_AN_LINK_SPEED	(BIT(2) | BIT(3))
@@ -689,6 +690,7 @@ struct axgbe_port {
 	unsigned int parallel_detect;
 	unsigned int fec_ability;
 	unsigned long an_start;
+	unsigned long kr_start_time;
 	enum axgbe_an_mode an_mode;
 
 	/* I2C support */
diff --git a/drivers/net/axgbe/axgbe_mdio.c b/drivers/net/axgbe/axgbe_mdio.c
index 4307a7560a..9fe30e83bc 100644
--- a/drivers/net/axgbe/axgbe_mdio.c
+++ b/drivers/net/axgbe/axgbe_mdio.c
@@ -370,6 +370,7 @@ static enum axgbe_an axgbe_an73_tx_training(struct axgbe_port *pdata,
 	reg |= AXGBE_KR_TRAINING_ENABLE;
 	reg |= AXGBE_KR_TRAINING_START;
 	XMDIO_WRITE(pdata, MDIO_MMD_PMAPMD, MDIO_PMA_10GBR_PMD_CTRL, reg);
+	pdata->kr_start_time = rte_get_timer_cycles();
 
 	PMD_DRV_LOG(DEBUG, "KR training initiated\n");
 	if (pdata->phy_if.phy_impl.kr_training_post)
@@ -500,6 +501,7 @@ static enum axgbe_an axgbe_an73_incompat_link(struct axgbe_port *pdata)
 
 	axgbe_an_disable(pdata);
 	axgbe_switch_mode(pdata);
+	pdata->an_result = AXGBE_AN_READY;
 	axgbe_an_restart(pdata);
 
 	return AXGBE_AN_INCOMPAT_LINK;
@@ -988,11 +990,34 @@ static void axgbe_check_link_timeout(struct axgbe_port *pdata)
 {
 	unsigned long link_timeout;
 	unsigned long ticks;
+	unsigned long kr_time;
+	int wait;
 
 	link_timeout = pdata->link_check + (AXGBE_LINK_TIMEOUT *
 					    2 *  rte_get_timer_hz());
 	ticks = rte_get_timer_cycles();
 	if (time_after(ticks, link_timeout)) {
+		if ((axgbe_cur_mode(pdata) == AXGBE_MODE_KR) &&
+		    pdata->phy.autoneg == AUTONEG_ENABLE) {
+			/* AN restart should not happen while KR training is in progress.
+			 * The while loop ensures no AN restart during KR training,
+			 * waits up to 500ms and AN restart is triggered only if KR
+			 * training is failed.
+			 */
+			wait = AXGBE_KR_TRAINING_WAIT_ITER;
+			while (wait--) {
+				kr_time = pdata->kr_start_time +
+					  msecs_to_timer_cycles(AXGBE_AN_MS_TIMEOUT);
+				ticks = rte_get_timer_cycles();
+				if (time_after(ticks, kr_time))
+					break;
+				/* AN restart is not required, if AN result is COMPLETE */
+				if (pdata->an_result == AXGBE_AN_COMPLETE)
+					return;
+				rte_delay_us(10500);
+			}
+		}
+
 		PMD_DRV_LOG(NOTICE, "AN link timeout\n");
 		axgbe_phy_config_aneg(pdata);
 	}
-- 
2.34.1