[PATCH v3 07/25] net/axgbe: enable PLL control for fixed PHY modes only

[Venkat Kumar Ande]

From: Venkat Kumar Ande <VenkatKumar.Ande at amd.com>

PLL control setting(RRC) is needed only in fixed PHY configuration to
fix the peer-peer issues. Without the PLL control setting, the link up
takes longer time in a fixed phy configuration.

Without the fix the user will not get the link come UP.

Driver implements SW RRC for Autoneg On configuration, hence PLL control
setting (RRC) is not needed for AN On configuration, and can be skipped.

Also, PLL re-initialization is not needed for PHY Power Off and RRC
commands. Otherwise, they lead to mailbox errors. Added the changes
accordingly.

Fixes: 09b0a36cc7ae ("net/axgbe: toggle PLL settings during rate change")
Cc: stable at dpdk.org
Signed-off-by: Venkat Kumar Ande <VenkatKumar.Ande at amd.com>
Acked-by: Selwin Sebastian <selwin.sebastian at amd.com>
---
 drivers/net/axgbe/axgbe_phy_impl.c | 9 +++++++--
 1 file changed, 7 insertions(+), 2 deletions(-)

diff --git a/drivers/net/axgbe/axgbe_phy_impl.c b/drivers/net/axgbe/axgbe_phy_impl.c
index f51830f800..bcefbf28f2 100644
--- a/drivers/net/axgbe/axgbe_phy_impl.c
+++ b/drivers/net/axgbe/axgbe_phy_impl.c
@@ -1228,6 +1228,10 @@ static void axgbe_phy_rx_reset(struct axgbe_port *pdata)
 
 static void axgbe_phy_pll_ctrl(struct axgbe_port *pdata, bool enable)
 {
+	/* PLL_CTRL feature needs to be enabled for fixed PHY modes (Non-Autoneg) only */
+	if (pdata->phy.autoneg != AUTONEG_DISABLE)
+		return;
+
 	XMDIO_WRITE_BITS(pdata, MDIO_MMD_PMAPMD, MDIO_VEND2_PMA_MISC_CTRL0,
 			XGBE_PMA_PLL_CTRL_MASK,
 			enable ? XGBE_PMA_PLL_CTRL_SET
@@ -1272,8 +1276,9 @@ static void axgbe_phy_perform_ratechange(struct axgbe_port *pdata,
 	axgbe_phy_rx_reset(pdata);
 
 reenable_pll:
-	 /* Re-enable the PLL control */
-	axgbe_phy_pll_ctrl(pdata, true);
+	/* Enable PLL re-initialization, not needed for PHY Power Off and RRC cmds */
+	if (cmd != 0 && cmd != 5)
+		axgbe_phy_pll_ctrl(pdata, true);
 
 	PMD_DRV_LOG(NOTICE, "firmware mailbox command did not complete\n");
 }
-- 
2.34.1