Inquiry on DPDK Support for Marvell AQtion 10Gbit Network Adapter

[Dilshodjon Mamadaliev]

Dear DPDK Development Team,

I hope this email finds you well. I am reaching out to inquire about *DPDK
support for the Marvell AQtion 10Gbit Network Adapter* on my system.

I am working on a *DPDK-based project* and considering integrating the *Marvell
AQtion 10Gbit NIC*.
*System Details:*

   - *Motherboard:* ASUS ProArt Z790 Creator WiFi
   - *Ethernet Interfaces:*
      - *1st Interface:* Intel(R) Ethernet Controller I226-V (2.5 Gbit)
      - *2nd Interface:* Marvell AQtion 10Gbit Network Adapter
   - *DPDK Setup:*
      - Installed DPDK and *vfio-pci* driver
      - Successfully *bound* the 1st (2.5Gbit) interface to *vfio-pci*
      - *Unable to bind* the 2nd (10Gbit) interface

*Issue:*

I followed the standard DPDK setup steps and was able to *bind and use the
2.5Gbit Intel interface* without issues. However, I *could not bind the
Marvell AQtion 10Gbit adapter* to DPDK.

Specifically, I would like to know:

   1. Whether *Marvell AQtion 10Gbit NIC* is officially supported by DPDK.
   2. If supported, which *DPDK driver* should be used for this NIC?
   3. If not currently supported, are there any *workarounds* or plans for
   future support?

I would appreciate any guidance, references, or recommendations regarding
this matter. Looking forward to your response.

Best regards,
Mamadaliev Dilshodjon
Master student in Pusan National University, Republic of Korea

<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
Virus-free.www.avast.com
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
<#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mails.dpdk.org/archives/dev/attachments/20250213/95ba5bcc/attachment.htm>