[PATCH RFC 3/4] doc: update prog guide to use rte_dma_op

[Kommula Shiva Shankar]

From: Pavan Nikhilesh <pbhagavatula at marvell.com>

Update the documentation to replace all instances of
rte_event_dma_adapter_op with rte_dma_op

Signed-off-by: Pavan Nikhilesh <pbhagavatula at marvell.com>
Change-Id: I0fe65d18f4601709826c11c6738cacec8991515d
---
 doc/guides/prog_guide/eventdev/event_dma_adapter.rst | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/doc/guides/prog_guide/eventdev/event_dma_adapter.rst b/doc/guides/prog_guide/eventdev/event_dma_adapter.rst
index e040d89e8b..e8437a3297 100644
--- a/doc/guides/prog_guide/eventdev/event_dma_adapter.rst
+++ b/doc/guides/prog_guide/eventdev/event_dma_adapter.rst
@@ -144,7 +144,7 @@ on which it enqueues events towards the DMA adapter using ``rte_event_enqueue_bu
    uint32_t cap;
    int ret;
 
-   /* Fill in event info and update event_ptr with rte_event_dma_adapter_op */
+   /* Fill in event info and update event_ptr with rte_dma_op */
    memset(&ev, 0, sizeof(ev));
    .
    .
@@ -244,11 +244,11 @@ Set event response information
 ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
 
 In the ``RTE_EVENT_DMA_ADAPTER_OP_FORWARD`` / ``RTE_EVENT_DMA_ADAPTER_OP_NEW`` mode,
-the application specifies the dmadev ID and vchan ID in ``struct rte_event_dma_adapter_op``
+the application specifies the dmadev ID and vchan ID in ``struct rte_dma_op``
 and the event information (response information)
 needed to enqueue an event after the DMA operation has completed.
 The response information is specified in ``struct rte_event``
-and appended to the ``struct rte_event_dma_adapter_op``.
+and appended to the ``struct rte_dma_op``.
 
 
 Start the adapter instance
-- 
2.43.0