[PATCH v11 1/1] ethdev: add link connector type

[Morten Brørup]

> From: Sunil Kumar Kori <skori at marvell.com>
> 
> Adding link connector parameter to provide the type
> of connection for a port like twisted pair, fiber etc.
> 
> Also added an API to convert the RTE_ETH_LINK_CONNECTOR_XXX
> to a readable string.
> 
> Signed-off-by: Nithin Dabilpuram <ndabilpuram at marvell.com>
> Signed-off-by: Sunil Kumar Kori <skori at marvell.com>
> ---

[...]

> +* **Added ethdev API to get link connector.**
> +
> +  * Added API to report type of link connection for a port.
> +    The following connectors are enumerated:
> +
> +   * NONE
> +   * TP
> +   * FIBER
> +   * BNC
> +   * DAC
> +   * XFI, SFI
> +   * MII, SGMII, QSGMII
> +   * AUI, XLAUI, GAUI, AUI, CAUI, LAUI
> +   * SFP, SFP_PLUS, SFP28, SFP_DD
> +   * QSFP, QSFP_PLUS, QSFP28, QSFP56, QSFP_DD
> +   * OTHER

Please use the string names, not the enum name, here.
E.g. Twisted Pair instead of TP, and SFP+ instead of SFP_PLUS.

> +
> +    By default, it reports ``RTE_ETH_LINK_CONNECTOR_NONE``
> +    unless driver specifies it.
> +
>  * **Added speed 800G.**
> 
>    Added Ethernet link speed for 800 Gb/s as it is well standardized in
> IEEE,
> @@ -124,6 +144,9 @@ ABI Changes
>  * eal: The structure ``rte_mp_msg`` alignment has been updated to 8
> bytes to limit unaligned
>    accesses in messages payload.
> 
> +* ethdev: Added ``link_connector`` field to ``rte_eth_link`` structure
> +  to report type of link connection for a port.

connection -> connector

[...]

>  /**
>   * A structure used to retrieve link-level information of an Ethernet
> port.
>   */
> @@ -343,6 +382,7 @@ struct rte_eth_link {
>  			uint16_t link_duplex  : 1;  /**<
> RTE_ETH_LINK_[HALF/FULL]_DUPLEX */
>  			uint16_t link_autoneg : 1;  /**<
> RTE_ETH_LINK_[AUTONEG/FIXED] */
>  			uint16_t link_status  : 1;  /**<
> RTE_ETH_LINK_[DOWN/UP] */
> +			uint16_t link_connector : 5;  /**<
> RTE_ETH_LINK_CONNECTOR_XXX */

Please use 6 bits instead of 5, so it is more future proof.
With the connector types already defined, 5 bits only leaves room for six more connector types.

Remember to update the value of RTE_ETH_LINK_CONNECTOR_OTHER from 31 to 63.

-Morten