[PATCH v2] net/axgbe: serialize PHY and link status access
Stephen Hemminger
stephen at networkplumber.org
Thu Nov 19 04:15:21 CET 2026
On Tue, 17 Nov 2026 15:18:05 +0530
Ajit Kumar <Ajit.Kumar at amd.com> wrote:
> From: Ajit Kumar <ajit.kumar at amd.com>
>
> The I2C and MDIO buses are shared by all ports on the device.
> axgbe_phy_get_comm_ownership() takes the per-port phy_mutex, which
> does not stop two ports in the same process from using the bus at
> once, causing I2C failures (-EAGAIN, -ENOTCONN, -ETIMEDOUT) and
> incorrect link status reporting.
>
> Add a driver-wide mutex taken before the per-port one, as the Linux
> xgbe driver does (xgbe_phy_comm_lock), which this DPDK PMD lost when
> its equivalent global lock became the per-port pdata->phy_mutex.
>
> This fix applies to ports owned by a single process. If ports of the
> same device are ever split across separate processes, or one port
> stays with the kernel xgbe driver, the hardware mutex registers
> remain the only arbitration between them; this is a pre-existing
> limitation, not something this patch changes.
Applied to next-net for 27.03 but I trimmed the commit message down.
The version change should be below cutline --- and the link status
part was not here anymore
More information about the dev
mailing list