[PATCH v2 1/2] net/i40e: fix MAC address removal

[Bruce Richardson]

On Mon, Sep 07, 2026 at 01:17:23PM +0200, David Marchand wrote:
> MAC addresses removal was tied with VMDq pools even when not used.
> So if VMDq is not enabled, no address would be ever removed.
> 
> Fixes: 9de506a6c781 ("ethdev: skip VMDq pools unless configured")
> 
> Signed-off-by: David Marchand <david.marchand at redhat.com>
> ---
> I could not test the change as my setups are KO atm.
> 
> Probably worth squashing in 9de506a6c781 before pulling to main
> 
> Changes since v1:
> - fixed compilation,
> 
> ---
>  drivers/net/intel/i40e/i40e_ethdev.c | 7 ++++++-
>  1 file changed, 6 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/net/intel/i40e/i40e_ethdev.c b/drivers/net/intel/i40e/i40e_ethdev.c
> index b6b2d291ee..3c01354c39 100644
> --- a/drivers/net/intel/i40e/i40e_ethdev.c
> +++ b/drivers/net/intel/i40e/i40e_ethdev.c
> @@ -4509,11 +4509,16 @@ i40e_macaddr_remove(struct rte_eth_dev *dev, uint32_t index)
>  	struct rte_ether_addr *macaddr;
>  	int ret;
>  	uint32_t i;
> +	bool vmdq;
>  	uint64_t pool_sel;
>  
>  	macaddr = &(data->mac_addrs[index]);
>  
> -	pool_sel = dev->data->mac_pool_sel[index];
> +	vmdq = (dev->data->dev_conf.rxmode.mq_mode & RTE_ETH_MQ_RX_VMDQ_FLAG) != 0;
> +	if (!vmdq)
> +		pool_sel = 1;
> +	else
> +		pool_sel = dev->data->mac_pool_sel[index];
>  
The explanation makes sense, but do we really need the new temporary
variable, rather than just checking the flag directly in the "if"?

Also, the rest of the code in this function, and the add function about it,
uses "pf->flags & I40E_FLAG_VMDQ" as a check for vmdq support. Is there a
reason we can't use that flag also here, rather than checking the rx
mq_mode flags?

/Bruce