[dts] [PATCH V1] Add sw eventdev test plan

Liu, Yong yong.liu at intel.com
Fri Nov 10 06:36:00 CET 2017


Yuwei,
Please add some descriptions in the header of the test plan.
I saw that all test cases depend on IXIA. Could we make those cases suitable for software packet generator like scapy?
Not everyone has expensive hardware instrument. For those who just want to check the basic status of eventdev, few thousands of packets are enough. 

Thanks,
Marvin

> -----Original Message-----
> From: dts [mailto:dts-bounces at dpdk.org] On Behalf Of Yuwei Zhang
> Sent: Thursday, November 02, 2017 10:54 PM
> To: dts at dpdk.org
> Cc: Zhang, Yuwei1 <yuwei1.zhang at intel.com>
> Subject: [dts] [PATCH V1] Add sw eventdev test plan
> 
> add software eventdev test plan
> 
> Signed-off-by: Yuwei Zhang <yuwei1.zhang at intel.com>
> ---
>  .../sw_eventdev_pipeline_sample_test_plan.rst      | 140
> +++++++++++++++++++++
>  1 file changed, 140 insertions(+)
>  create mode 100644 test_plans/sw_eventdev_pipeline_sample_test_plan.rst
> 
> diff --git a/test_plans/sw_eventdev_pipeline_sample_test_plan.rst
> b/test_plans/sw_eventdev_pipeline_sample_test_plan.rst
> new file mode 100644
> index 0000000..926adf0
> --- /dev/null
> +++ b/test_plans/sw_eventdev_pipeline_sample_test_plan.rst
> @@ -0,0 +1,140 @@
> +.. Copyright (c) <2013-2017>, Intel Corporation
> +   All rights reserved.
> +
> +   Redistribution and use in source and binary forms, with or without
> +   modification, are permitted provided that the following conditions
> +   are met:
> +
> +   - Redistributions of source code must retain the above copyright
> +     notice, this list of conditions and the following disclaimer.
> +
> +   - Redistributions in binary form must reproduce the above copyright
> +     notice, this list of conditions and the following disclaimer in
> +     the documentation and/or other materials provided with the
> +     distribution.
> +
> +   - Neither the name of Intel Corporation nor the names of its
> +     contributors may be used to endorse or promote products derived
> +     from this software without specific prior written permission.
> +
> +   THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
> +   "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
> +   LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
> +   FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
> +   COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
> +   INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
> +   (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
> +   SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
> +   HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
> +   STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
> +   ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED
> +   OF THE POSSIBILITY OF SUCH DAMAGE.
> +===============================
> +Eventdev Pipeline SW PMD Tests
> +===============================
> +
> +Prerequistites
> +==============
> +
> +Test Case 1: Keep the packets order with one ordered stage in single-flow
> and multi-flow
> +=========================================================================
> ===============
> +Description: the sample only guarantee that keep the packets order with
> only one stage.
> +
> +1. Run the sample with below command:
> +# ./build/eventdev_pipeline_sw_pmd --vdev event_sw0 -- -r2 -t4 -e8 -w F0
> -s1 -n0 -c32 -W1000 -o -D
> +Parameters:
> +-r2, -t4, -e8: allocate cores to rx, tx and shedular
> +-w: allocate cores to workers
> +-s1: the sample only contain 1 stage
> +-n0: the sample will run forever without a packets num limit
> +
> +2. Send traffic from ixia device with same 5 tuple(single-link) and with
> different 5-tuple(multi-flow)
> +
> +3. Observe the packets received by ixia device, check the packets order.
> +
> +Test Case 2: Keep the packets order with atomic stage in single-flow and
> multi-flow
> +=========================================================================
> ==========
> +Description: the packets' order which will pass through a same flow
> should be guaranteed.
> +
> +1. Run the sample with below command:
> +# ./build/eventdev_pipeline_sw_pmd --vdev event_sw0 -- -r2 -t4 -e8 -w F0
> -s2 -n0 -c32 -W1000 -a -D
> +
> +2. Send traffic from ixia device with same 5 tuple(single-link) and with
> different 5-tuple(multi-flow)
> +
> +3. Observe the packets received by ixia device, ensure packets in each
> *flow* remain in order, but note that flows may be re-ordered compared to
> eachother.
> +
> +
> +Test Case 3: Check load-balance behavior with atomic type in single-flow
> and multi-flow situations
> +=========================================================================
> =========================
> +Description: In multi-flow situation, sample should have a good load-
> blanced behavior; in single-flow, the load-balanced behavior is not
> guaranteed;
> +
> +1. Run the sample with below command:
> +# ./build/eventdev_pipeline_sw_pmd --vdev event_sw0 -- -r2 -t4 -e8 -w F0
> -s1 -n0 -c32 -W1000 -a -D
> +
> +2. Use traffic generator to send huge number of packets:
> +In single-flow situation, traffic generator will send packets with the
> same 5-tuple which is used to calculate rss value;
> +In multi-flow situation, traffice generator will send packets with
> different 5-tuple;
> +
> +3. Check the load-balance bahavior by the workload of every worker.
> +
> +Test Case 4: Check load-balance behavior with order type stage in single-
> flow and multi-flow situations
> +=========================================================================
> ==============================
> +Description: A good load-balanced behavior should be guaranteed in both
> single-flow and multi-flow situations.
> +
> +1. Run the sample with below command:
> +# ./build/eventdev_pipeline_sw_pmd --vdev event_sw0 -- -r2 -t4 -e8 -w F0
> -s1 -n0 -c32 -W1000 -o -D
> +
> +2. Use traffic generator to send huge number of packets:
> +In single-flow situation, traffic generator will send packets with the
> same 5-tuple which is used to calculate rss value;
> +In multi-flow situation, traffice generator will send packets with
> different 5-tuple;
> +
> +3. Check the load-balance bahavior by the workload of every worker.
> +
> +Test Case 5: Check load-balance behavior with parallel type stage in
> single-flow and multi-flow situations
> +=========================================================================
> =================================
> +Description: A good load-balanced behavior should be guaranteed in both
> single-flow and multi-flow situations.
> +
> +1. Run the sample with below command:
> +# ./build/eventdev_pipeline_sw_pmd --vdev event_sw0 -- -r2 -t4 -e8 -w F0
> -s1 -n0 -c32 -W1000 -p -D
> +
> +2. Use traffic generator to send huge number of packets:
> +In single-flow situation, traffic generator will send packets with the
> same 5-tuple which is used to calculate rss value;
> +In multi-flow situation, traffic generator will send packets with
> different 5-tuple;
> +
> +3. Check the load-balance bahavior by the workload of every worker.
> +
> +Test Case 6: Performance test for atomic type of stage
> +======================================================
> +Description: Execute performance test with atomic type of stage in
> single-flow and multi-flow situation.
> +We use 4 worker and 2 stage as the test background.
> +
> +1. Run the sample with below command:
> +# ./build/eventdev_pipeline_sw_pmd --vdev event_sw0 -- -r2 -t4 -e8 -w F0
> -s1 -n0 -c32
> +
> +2. use traffic generator to send huge number of packets(with same 5-tuple
> and different 5-tuple)
> +
> +3. observe the speed of packets received.
> +
> +Test Case 7: Performance test for parallel type of stage
> +========================================================
> +Description: Execute performance test with atomic type of stage in
> single-flow and multi-flow situation.
> +We use 4 worker and 2 stage as the test background.
> +
> +1. Run the sample with below command:
> +# ./build/eventdev_pipeline_sw_pmd --vdev event_sw0 -- -r2 -t4 -e8 -w F0
> -s1 -n0 -c32
> +
> +2. use traffic generator to send huge number of packets(with same 5-tuple
> and different 5-tuple)
> +
> +3. observe the speed of packets received.
> +
> +Test Case 8: Performance test for ordered type of stage
> +=======================================================
> +Description: Execute performance test with atomic type of stage in
> single-flow and multi-flow situation.
> +We use 4 worker and 2 stage as the test background.
> +
> +1. Run the sample with below command:
> +# ./build/eventdev_pipeline_sw_pmd --vdev event_sw0 -- -r2 -t4 -e8 -w F0
> -s1 -n0 -c32
> +
> +2. use traffic generator to send huge number of packets(with same 5-tuple
> and different 5-tuple)
> +
> +3. observe the speed of packets received.
> \ No newline at end of file
> --
> 2.14.1.windows.1



More information about the dts mailing list