[dpdk-users] DPDK TX problems

[Hrvoje Habjanić]

> Hi.
>
> I did write an application using dpdk 17.11 (did try also with 18.11),
> and when doing some performance testing, i'm seeing very odd behavior.
> To verify that this is not because of my app, i did the same test with
> l2fwd example app, and i'm still confused by results.
>
> In short, i'm trying to push a lot of L2 packets through dpdk engine -
> packet processing is minimal. When testing, i'm starting with small
> number of packets-per-second, and then gradually increase it to see
> where is the limit. At some point, i do reach this limit - packets start
> to get dropped. And this is when stuff become weird.
>
> When i reach peek packet rate (at which packets start to get dropped), i
> would expect that reducing packet rate will remove packet drops. But,
> this is not the case. For example, let's assume that peek packet rate is
> 3.5Mpps. At this point everything works ok. Increasing pps to 4.0Mpps,
> makes a lot of dropped packets. When reducing pps back to 3.5Mpps, app
> is still broken - packets are still dropped.
>
> At this point, i need to drastically reduce pps (1.4Mpps) to make
> dropped packets go away. Also, app is unable to successfully forward
> anything beyond this 1.4M, despite the fact that in the beginning it did
> forward 3.5M! Only way to recover is to restart the app.
>
> Also, sometimes, the app just stops forwarding any packets - packets are
> received (as seen by counters), but app is unable to send anything back.
>
> As i did mention, i'm seeing the same behavior with l2fwd example app. I
> did test dpdk 17.11 and also dpdk 18.11 - the results are the same.
>
> My test environment is HP DL380G8, with 82599ES 10Gig (ixgbe) cards,
> connected with Cisco nexus 9300 sw. On the other side is ixia test
> appliance. Application is run in virtual machine (VM), using KVM
> (openstack, with sriov enabled, and numa restrictions). I did check that
> VM is using only cpu's from NUMA node on which network card is
> connected, so there is no cross-numa traffic. Openstack is Queens,
> Ubuntu is Bionic release. Virtual machine is also using ubuntu bionic
> as OS.
>
> I do not know how to debug this? Does someone else have the same
> observations?
>
> Regards,
>
> H.
There are additional findings. It seems that when i reach peak pps rate,
application is not fast enough, and i can see rx missed errors on card
statistics on the host. At the same time, tx side starts to show
problems (tx burst starts to show it did not send all packets). Shortly
after that, tx falls apart completely and top pps rate drops.

Since i did not disable pause frames, i can see on the switch "RX pause"
frame counter is increasing. On the other hand, if i disable pause
frames (on the nic of server), host driver (ixgbe) reports "TX unit
hang" in dmesg, and issues card reset. Of course, after reset none of
the dpdk apps in VM's on this host does not work.

Is it possible that at time of congestion DPDK does not release mbufs
back to the pool, and tx ring becomes "filled" with zombie packets (not
send by card and also having ref counter as they are in use)?

Is there a way to check mempool or tx ring for "left-owers"? Is is
possible to somehow "flush" tx ring and/or mempool?

H.