[dpdk-users] Enable MLX5 driver v20.11
Gerry Wan
gerryw at stanford.edu
Sun Dec 13 12:25:14 CET 2020
Thanks,
I updated my MLNX_OFED to 5.1-2.5.8.0, which was tested against for this
DPDK release.
To install, I ran ./mlnxofedinstall --dpdk --upstream-libs --with-mft
--with-kernel-mft
then /etc/init.d/openibd restart
Now, ninja install gives me ../drivers/net/mlx4/mlx4_glue.h:16:10: fatal
error: infiniband/mlx4dv.h: No such file or directory
What other steps am I missing?
On Sun, Dec 13, 2020 at 12:35 AM Raslan Darawsheh <rasland at nvidia.com>
wrote:
> Hi Gerry,
>
> Starting V20.11 the build system was switched to use meson only,
> And if you have necessary packages for MLX5 (a.k. rdma-core) it will be
> built automatically.
>
> As for your question if you still don't need to bind mlx5 driver that's
> true, its still valid.
>
> Kindest regards,
> Raslan Darawsheh
>
> > -----Original Message-----
> > From: users <users-bounces at dpdk.org> On Behalf Of Gerry Wan
> > Sent: Sunday, December 13, 2020 1:22 AM
> > To: users at dpdk.org
> > Subject: [dpdk-users] Enable MLX5 driver v20.11
> >
> > Hello,
> > I am trying to update my DPDK version from 20.08 to 20.11. I am using the
> > mlx5 driver, and previously to enable it I had to set
> > CONFIG_RTE_LIBRTE_MLX5_PMD=y in config/common_base. In 20.11, I see
> > no
> > option to do so. I was able to build my application (and the sample
> > applications), but running rte_eth_dev_count_avail() returns 0 and cannot
> > find any ports.
> >
> > The steps I did to build DPDK from source were:
> >
> > $ meson build
> >
> > $ cd build
> >
> > $ sudo ninja install
> >
> > $ sudo ldconfig
> >
> >
> > Normally I would edit dpdk-20.xx/config/common_base before meson build,
> > but
> > that file is gone.
> >
> > What are the steps I need to take to enable mlx5 driver? I also recall
> that
> > I don't need to bind the mlx5 driver, is that still the case?
> >
> > Thanks
>
More information about the users
mailing list